080QTFANS- Install Guide

IMPORTANT: WARRANTYBefore using any MONITECH product, please carefully review this manual as well as any additional documentation provided with your shipment.

Attempting any of the following will void product warranty:

• Unauthorized repairs or parts replacement
• Inappropriate use or placement: exposing the product to liquids, harmful gases, electrical shock, physical shock, temperatures beyond the range of -4°F to 140°F (-20°C to 60°C)
• Use of electrical voltage other than 12V 4.16A (power supply and AC cable provided)
• Removal or modification of serial, product, or warranty labels.

REMOVAL:

• Step #1) Turn off main power, turn off machine.
• Step #2) Open up the cover. Unplug all the connectors shown in the pictures. Take a picture of all connector positions before unplugging as the connectors must be plugged back in after installing the new monitor.
• Step #3) Remove the CRT housing from the back by removing all the fasteners holding the CRT housing in place. Retain all screws for installation of your new monitor.
• Step #4) The neck board, the yolk, and all other boards from the CRT housing are not needed. Remove & retain the power cable & video cable.

ASSEMBLY:

• Step #1) Now you are left with the original CRT frame, which can be discarded. First, you must remove the black screws on the side of the Monitech Monitor as shown below.
• Step #2) Align the metal bracket (MK013) to match the slots on the side, and fasten the black screws to mount the metal bracket (MK013) to the LCD.
• Step #3) Your Fanuc monochrome CRT monitor accepts 15Vdc to 24Vdc. Since your new Monitech LCD accepts only 12Vdc, your LCD Upgrade Kit contains a converter cable. It converts 15Vdc or 24Vdc to 12Vdc. Using a black marker, mark the two ground wires. Cut and strip the two ground wires. Strip both wires and crimp them with our two black wires with red butt connectors. Do the same for the 24VDC wires, cutting, stripping, and crimping them to our red wires with red butt connectors.

INSTALLATION:

• Step #1) This next step will show how to mount your new monitor to your front panel. Use the supplied foam strip to cover any gaps and act as a frame within the bezel. Now, using the 4 screws provided, mount the new monitor to the back of your front panel.
• Step #2) Reconnect all connectors to their correct location (Use your pictures if necessary).
• Step #3) Plug the BLUE video connector into the blue socket as shown below. Plug VGA from the adaptor to our monitor, and the power jack.
• Turn ON main power and machine power. If you’re seeing a blue screen, flip the blue Honda video cable around 180 degrees and plug it back in. *A power supply (MAP307) is provided for testing only. The LCD user guide can be used to center your screen once fully installed and video is evident.

TROUBLESHOOTING:

1. If you’re seeing a blue screen, flip the blue Honda video cable around 180 degrees and plug it back in.
2. If your monitor is showing black after powering up, check the jumper settings on our board. They should be set to 3 & 7 ON. If you adjust the power off the machine, then adjust, and power back on.

Keep your FANUC workstations and other HMIs up and running!